WT-ROUTER Router Installation Instructions
1
Refer to the
QuickLIT website
for the most up-to-date version of this document.
Application
The WT-ROUTER Router relays wireless
transmissions from a Johnson Controls® WT-4000
Series Pneumatic-to-Direct Digital Control (DDC)
Room Thermostat to other WT-ROUTER Routers or
to a Johnson Controls WT-BAC-IP Gateway. Adding
routers to a wireless mesh network enhances the
robustness of the network by extending the wireless
mesh communication range up to 750 ft (229 m).
In addition, the routers provide multiple routes of
communication with the gateway.
The WT-ROUTER Router installs in minutes with no
need to run network cables. An
STS
LED indicator
(Figure 1) allows for strategic positioning in areas with
reliable network connectivity. The router is powered by
a low-voltage 5 to 30 VDC power supply.
The WT-ROUTER Router is designed for indoor,
intra-building applications only. The router uses
direct-sequence, spread-spectrum RF technology,
and operates on the 2.4 GHz Industrial, Scientific,
and Medical (ISM) band. The router also meets the
IEEE 802.15.4 standard for low power, low duty cycle
RF transmitting systems.
North American Emissions Compliance
United States
Canada
IMPORTANT:
Use the WT-ROUTER Router only to
provide an input to equipment under normal
operating conditions. Where failure or malfunction of
the router could lead to personal injury or property
damage to the controlled equipment or other
property, additional precautions must be designed
into the control system. Incorporate and maintain
other devices, such as supervisory or alarm systems
or safety or limit controls, intended to warn of or
protect against failure or malfunction of the router.
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference,
and
2.
This device must accept any interference
received, including interference that may cause
undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Industry Canada Statement
The term
IC
before the certification/registration
number only signifies that the Industry Canada
technical specifications were met.
Le terme « IC » précédant le numéro d'accréditation/
inscription signifie simplement que le produit est
conforme aux spécifications techniques d'Industry
Canada.
WT-ROUTER Router
Installation Instructions
WT-ROUTER
Part No. 24-10732-13, Rev. B
Issued August 2017
24- 10732- 13, Rev . B
