H3C S5500-SI Series, Operation Manual

Page: 850 / 1217

1-15
Activating an RRPP Domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the
RRPP domain on the current device.
Perform this operation on all nodes in the RRPP domain.
Follow these steps to activate an RRPP domain:
To do… Use the command… Remarks
Enter system view system-view —
Enable RRPP rrpp enable
Required
Disabled by default
Enter RRPP domain view rrpp domain domain-id —
Enable the specified RRPP ring ring ring-id enable
Required
Disabled by default
On an edge node or assistant-edge node, enable/disable the primary ring and subrings separately as
follows:
z
Enable the primary ring of an RRPP domain before enabling subrings of the RRPP domain.
z
Disable the primary ring of an RRPP domain after disabling all subrings of the RRPP domain.
Configuring RRPP Timers
Perform this configuration on the master node of an RRPP domain.
Follow these steps to configure RRPP timers:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Configure the Hello timer and
Fail timer for the RRPP domain timer hello-timer hello-value
fail-timer fail-value
Required
By default, the Hello timer value
is 1 second and the Fail timer
value is 3 seconds.