maintenance & safety inspections
file: n:\article\cos14310m5-v1_06hpc-en\20120215_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_running_machine.doc
© 2012 h/p/cosmos sports & medical gmbh [email protected] created 15.02.2012 printed 15.02.2012 page: 140 of 213
Alternatively you can also use a spray (with a thin spraying canal) of fat-dissolving fluid (e.g. braking detergent). The
pressure on the detergent when coming through the spraying canal will cleanse the optics of the light barrier.
When adjusting the light barrier take care to keep the
following guidelines for the spaces between the glass [3]
and the casing [4] of the light barrier: Cleft [1] axial
approx. 1 mm/radial approx. 1 mm left and right
according to illustration above. The imaginary extension
of the light barrier has to pass through the centre [2] of
motor shaft.
Right hand side: The distance [1] between induction
sensors [2] to the cogwheel [3] must not be bigger than
0.8 mm.
[9.K]
Cleansing and adjustment of the light-barrier at belt-re-entry-zones
Some models (running surface 200/75cm and bigger) are equipped with light-barriers at the running belt re-entry zone
(rear position and front position for the reverse of belt rotation). As a safety measurement the light barriers effect a
quick-stop function when the light stream is interrupted by a hand, a falling towel, a coat and of course, also by dust at
the glass and/or reflector of the light barrier.
To avoid unwanted switch off (quick stop), the light barrier and the reflector glass should be cleansed carefully with a
cloth moistened with alcohol in intervals of 1 week, depending on the air and dust conditions in the room.
Adjustment (direction and focus) of the light barrier can be checked when it is dark in the room.
In case the cleansing of the light barrier does not result in success, you need to check and correct adjustment (direction
and focus) of the light barrier. A special small screwdriver is required for adjustment of the focus. Talk about the
procedure to your h/p/cosmos service partner.
Light barrier must not be exposed to dazzling flash light of cameras. They might turn off and stop
the running belt abruptly.
