GRASS VALLEY JUPITER CONTROL PANEL L32 -, Instruction Manual

Page: 108 / 216

108 JUPITER L-S and LCD Series Control Panel Instruction Manual
Section 6 — L-S Series Panel Operation
Executing a Sequence (Salvo)
After a sequence is created and downloaded (see Setting Up a Salvo with a
Sequence Set on page 63 ) it can be executed as follows:
Direct Execution
In order to directly execute a sequence, that must be assigned to a panel
button (see
Button Assignment on page 109 ).
1. Press the assigned Sequence button for the desired sequence.
All the Destinations in the sequence will immediately be switched to their
designated Sources.
Direct Execution with Preset
Preset allows you to select a sequence assigned to buttons and identify it by
name before executing it.
1.
Press
Preset
so it is illuminated.
2. Press the low amber button for the desired sequence. The sequence will
NOT execute. Instead, the
Take
button will illuminate and the name of
the sequence will be displayed on the menu. Different sequences can be
selected with their assigned buttons until the correct one is found.
3. Press
Take
. That sequence will execute and all the Sources will be
switched to their Destinations.
4. To exit Preset mode, press the
Preset
button so it is turned off.
Menu Execution
1.
Press the
Menu
button. The Status/Destination window will display
configuration modes.
2.
Use the
Up/Down
arrow buttons to scroll to
Select Sequence?
mode.
3. Press
Take
. Sequence names will appear in the Status window.
4.
Use the
Up/Down
arrow buttons to scroll to the desired sequence.
5. Press
Take
. All the Destinations in the sequence will be switched to their
designated Sources.
Source Swap Mode
Turning on Source Swap mode allows rapid permits flip-flop switching
between two Sources. The last selected Source is retained (displayed in