GRASS VALLEY GV MATRIX, User Manual

Page: 67 / 115

51
GV Matrix
User Manual
Upgrading the CPU-ETH3 Controller
Upgrading the CPU-ETH3 firmware must be accomplished via a web page served by the
controller, and accessed through its ethernet port using a browser.
To upgrade the CPU-ETH3 controller
1 Obtain an upgrade file from Grass Valley.
The file will be named 3034-01P80-###_CPU-ETH3-BASIC-Firmware_v#.#.#.zip , where
### is the firmware release version number.
2 Unzip the file, and save the expanded file, which will be named cpueth3-upgrade-
#.#.#.bbb.tar.gz
This file is the file you will need to upgrade the CPU-ETH3 card in step 7 below.
3 Using a browser on your network, browse to the IP address of the CPU-ETH3 card.
If you are using iControl, double-click the controller in the iNavigator page, and select
NETWORK | ETH to see the IP address.
4 You will be asked for a username and password - the default values are:
• "Username = admin
• "Password = (leave blank)
The CPU-ETH3 web page will open in your browser.
5 In the left-side menu, select Tools | Upgrade Firmware .
TIME OPTIONS TIME [[HH]:[MM]:[SS]]
DATE [DD]:[MMM]:[YY]]
NTP CLIENT [ENABLE, DISABLE]
NTP SERVER LIST IP ADDRESS [[0...255].[0...255].[0...255].[0...255]]
ADD IP ADDRESS [[0...255].[0...255].[0...255].[0...255]]
REMOVE ADDRESS [[0...255].[0...255].[0...255].[0...255]]
NTP REFRESH [EVERY [HH] HOUR]
ALARM REPORT PS FAILURE [NONE, GPI]
FAN FAILURE [NONE, GPI]
GPI REPORT [ENABLE, DISABLE]
CTRL VERSION [FIRMWARE V.XXX]
BOOT-LOADER VER [VERSION X.X.X]
OPTIONS [LINK REDUN ON/OFF]
FACTORY DEFAULT [RESTORE] (Sets all parameters shown above to their underlined default values)
CTRL EXECUTION [REBOOT]
Reported value; cannot be changed. List of values that can be selected.
Default value is underlined.
Level 1 Level 2 Level 3