Documentation HG G-73650ZD | English, Revision 05 | Date: 09.03.2017 | www.goetting-agv.com
142
Chapter 9: Trouble Shooting
Transponder is not
evaluated
1. Signal strength of the trans-
ponder is too low
2. Position pulse missing
3. Not enough distance to
other transponders
1. Check ground reinforcement; minimize
reading distance; check adjustment of
antenna; possible defect of the antenna
or transponder.
2. Reduce threshold for antenna position
pulse; re-connect antenna properly
3. Relocate the transponder. Adjust parame-
ters
Driving in automatic
mode not possible
1. Error is displayed in menu
Status Error 4.2.5 on page
55
2. Speed is not transmitted
1. Check the indicated error message in
2. Use P CAN View or a Profinet tool to
check, whether the speed of the wheel is
transmitted at all.
Segment list is not
accepted
1. No release for vehicle cont-
rol unit
2. Incomplete sequence of
segments
1. Use the Parameter Test menu (section
4.10 on page 83) to activate the clear-
ance by switching to the mode Idle
2. - Call the segments in the correct order
- Check whether the end positions of the
segments are the start positions of the
following segments.
- Checke whether the orientation of the
segments fits (Exception: When the Attri-
bute Spot Turn is set for a segment)
Error
Possible cause(s) of failure
Possible diagnosis / trouble shooting
Table 51
Trouble Shooting (part 2 of 2)