Documentation HG G-73650ZD | English, Revision 05 | Date: 09.03.2017 | www.goetting-agv.com
146
Chapter 11: Appendix
C Configuration of the Ethernet Interface Parameters via
SIO 2
Normal communication with the navigation controller is performed via the Ethernet inter-
face. In case the settings of the Ethernet interface are not known, Götting provides a pro-
gram to read and change the Ethernet parameters via a serial interface SIO 2.
1.
Download the program
HG61430-D Vxxx setup.zip
from:
Link
http://goetting-agv.com/components/73650
2.
Use a cable matching your computer‘s hardware to connect a serial port of the com-
puter to the RS 232 interface SIO 2.
3.
Unpack the downloaded ZIP archive and start the EXE. The following screen comes
up:
Figure 85
Screenshot: Software for setting t. parameters of t. Ethernet interface via SIO 2
BEWARE!
The button „Format Flash“ erases the interal memory of the navigation controller. This
should only be carried out in exceptional cases to resolve errors! The ethernet settings of
the navigation controller remain but all configurations including the config file, seg-
ments.csv and transponder.csv are deleted and have to be re-uploaded (see chapter 4 on
4.
Choose the correct COM port. The program only shows available ports. However in
case there are more than one it cannot detect to which the navigation controller is
connected.
5.
Optionally use „Read Setup“ to fetch the current settings from the navigation control-
ler.
Choose COM port
Read current setup (optional)
Write new parameters
Adjust parameters
Status messages
Quit program
Format RAM (caution, see below)
