Page
•
globalcontract.com
49
• Summer 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
Ganging Brackets
Connecting Seat to Boulevards panels
Ganging bracket kit serves to connect seat to seat or seat to bridges storage in
line. Place units into their fi nal position.
STEP 1: Use Phillips or Robertson screw bit to loosen 4 machine screws (B) on
the inner side of support legs.
STEP 2: Slide the Ganging bracket under partially loosened screw (B).
STEP 3: Push seats together and rotate the Ganging bracket to engage the other
partially loosened screw (B).
STEP 4: Ensure that the seat are aligned and re-tighten the B screws.
Some bridges collaborative seating units have been designed to connect to
Boulevard and Evolve panel vertical slots. These specialized units are supported
by a leg at the front and by a set of included brackets at the back.
Note: the width of the seat must correspond with the width of the
panel. Boulevard brackets are identifi ed with “B”, Evolve brackets with “E”.
STEP 1: Insert both brackets (left and right) into the panel vertical slots as
illustrated and ensure that the bottom of both brackets is positioned just above
the raceway cover.
STEP 2: Push the anti-dislodgment locks in so that both fully engage with the
panel slots.
STEP 3: Slice the bottom fabric along the seat structure back wall, just long
enough to allow the bracket to go through.
STEP 4: Drop the rear edge of the seat into both brackets and level front level-
ers as required.
STEP 5: Secure the seat by driving two supplied screws through each bracket,
into the rear seat board, from the inside of the seat.
1b
B
4
4
3
2
2
1
4
3
5
5
B
B
NOT UL LISTED
