•Page
globalcontract.com
4
• Summer 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
Supporting Legs And Beams Cont.
STEP 3: Position beam’s end bracket over leg’s horizontal, rectangular tube.
STEP 4: Secure top and bottom bracket ends with two supplied screws. But do not
tighten the bottom screw.
Level the whole assembly.
STEP 5: Place worksurfaces on top of table structure, align them and interconnect
them using fl at brackets.
STEP 6: Align this worksurface assembly with legs and secure with screws. Proceed
from one corner to the opposite one.
STEP 7: Ensure legs are vertical and tighten the bottom screw.
STEP: 8 Adjust nylon set screws in the middle of the beam to fl atten the worksurface
(if required).
6
3
5
8
7
4
Central beam position on round
legs and 24” rectangular legs
Offset beam
position
Offset beam
position on 30”
rectangular
legs
Back Edge Underside
Accessory
Holes
Front Edge
NOTE
: Correct Leg orientation
End of worksurface
