Page
•
globalcontract.com
35
• Summer 2017
GLOBAL
Contract
Table Mounted Panels
INSTALLATION GUIDELINES
1
2
3
4
5
STEP 1: Back 2 Back work surfaces are provided with pilot holes for accurate
location of Back 2 Back divider brackets. Align the brackets with pilot holes and
secure with supplied screws.
STEP 2: Place panel frame on top of Back to back divider brackets, and center
with work surface.
STEP 3: Line up holes in the bottom of the panel with the Back to back divider
bracket holes and secure with machine screws.
STEP 4: Insert support bracket against the inner vertical wall as indicated above.
STEP 5: Guide bracket up the vertical extrusion, hold top of panel and hammer
bracket until fl ush with work surface and secure with supplied screws.
STEP 6: Secure support bracket through the inside of panel with provided ma-
chine screws. Holes in the bracket should line up with holes in panel.
Step 7: For installing units with power distribution modules, proceed to do so.
After installing power distribution modules (if applicable) fi nish by closing the full
fabric tile; or for units with a combo accessory tile & fabric.
6
NOT UL LISTED
