USER MANUAL
POSITION CONTROLLER THESI 320
MT02_A41_A_TH320_GIVI_ENG rev. E
Pag. 49/60
With the automatic operation mode it is possible to run previously stored programs.
Example of immediate running of program 02
5 0.0
Press
to enter the selection of the
program to be run
2 0 0.0
01 01*
Note: the led of the AUTO key is on to indicate that the instrument is in automatic operation mode.
The number of the last program run will start flashing (e.g. program 01).
Enter the number of the program to be set (e.g. program 02).
x x x.x
Press
to start positionings of the first
cycle
x x x.x
01 02
After positioning has been executed, the led of the START key switches off and the OK
POSITION output will be enabled.
5 0.0
The display will show the
positions reached
1 0 0.0
01 02
)
Positioning will occur considering the parameters’ settings (e.g. speed change,
mechanical backlash recovery, positioning tolerance, waiting times, etc.).
Repetitions will be counted when the INCREASE CYCLE input closes.
3
Example after 3 repetitions
1 0 0.0
01 02
At the end of the programmed repetitions counting (e.g. after 10 closures), the OK
POSITION output will be disabled and the led of the START key will turn on.
x x x.x
The positioning of the next cycle
will start
x x x.x
02 02
At the end of the counting of the programmed repetitions of the last cycle, the OK
POSITION output will be disabled.
4 5 0.0
The positions will start flashing to
indicate the conclusion of
machining
5 0 0.0
03 02
AUTOMATIC OPERATION
Summary of Contents for THESI 320
Page 1: ...User Manual Position Controller T TH HE ES SI I 3 32 20 0 www givimisure it...
Page 57: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 57 60 NOTES...
Page 58: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 58 60 NOTES...
Page 59: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 59 60 NOTES...
