USER MANUAL
POSITION CONTROLLER THESI 320
MT02_A41_A_TH320_GIVI_ENG rev. E
Pag. 50/60
4 5 0.0
Press
to go back to the selection of a
new program to run
5 0 0.0
01 02*
4 5 0.0
Press
to quit automatic operation and
go back to manual operation
5 0 0.0
Notes:
1) Before running a program, it is possible to display its cycles. Once the desired program
number has been entered, use the ENTER key to display the positions of the first cycle.
2) During the display of the program’s cycles, it is possible to display the number of the
programmed repetitions. After positioning on the desired cycle, press the FUNCTION
key.
3) A program can be run starting from any of its cycles. Once the number of the program
has been entered, display the desired cycle and press START to execute it.
4) The same program can be run continuously. Once the program has been started, press
the AUTO key and the led will flash. In this way, at the end of the repetitions counting of
the last cycle, the program will automatically resume from the first cycle.
5) To terminate the program, press the STOP key; the cycle/program displays will flash to
signal the interruption.
Press the START key to resume the execution or press the STOP key again to go back
to the programs selection.
Summary of Contents for THESI 320
Page 1: ...User Manual Position Controller T TH HE ES SI I 3 32 20 0 www givimisure it...
Page 57: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 57 60 NOTES...
Page 58: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 58 60 NOTES...
Page 59: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 59 60 NOTES...
