USER MANUAL
POSITION CONTROLLER THESI 320
MT02_A41_A_TH320_GIVI_ENG rev. E
Pag. 46/60
Semi-automatic operation allows for a single automatic positioning of the axes. It is
possible to switch from manual to semi-automatic operation by selecting the axes to be
positioned, pressing the corresponding key, entering the arrival positions and, eventually,
the number of repetitions (1-99) that will be counted once positioning has been executed.
Example: setting positions X = 100.0 mm Y = 350.5 mm with 4 repetitions
0 0 0 0 0.0
*
Press
to select semi-automatic
operation and enter X axis
setting
2 0 0.0
Enter the position value, aligning it to the decimal point displayed (100.0).
1 0 0.0
Press
to confirm the value and enter
the Y axis setting
0 0 0 0 0.0
*
Enter the position value, aligning it to the decimal point displayed (350.5).
0 1
*
Press
to confirm the value and go on
setting the number of repetitions
0 4
*
Press
to set the 4 repetitions
Note:
at this point, it is possible to program also the status (ON/OFF) that the axes AUX outputs
will have to assume during positioning. The ON/OFF status has to be programmed on both
AUX outputs, regardless of the axes activation.
If required, follow the instructions below, otherwise go to point 1.
Example: AUX X axis = ON AUX Y axis = ON
o F F
*
Press
to go on setting the AUX outputs
status
o F F
o n
*
Press
to program the ON status of the
X axis output
o F F
SEMI-AUTOMATIC OPERATION
Summary of Contents for THESI 320
Page 1: ...User Manual Position Controller T TH HE ES SI I 3 32 20 0 www givimisure it...
Page 57: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 57 60 NOTES...
Page 58: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 58 60 NOTES...
Page 59: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 59 60 NOTES...
