USER MANUAL
POSITION CONTROLLER THESI 320
MT02_A41_A_TH320_GIVI_ENG rev. E
Pag. 47/60
o n
Press
to confirm and proceed with the
Y axis programming
o F F
*
o n
Press
to program the ON status of the
Y axis output
o n *
POINT (1)
x x x.x
Press
to start positioning. The led of
the START key will turn on
x x x.x
At the end of positioning, the led of the START key will turn off and the OK POSITION
output will be enabled.
1 0 0.0
The display will show the
position reached
3 5 0.5
)
Positioning will occur considering the parameters’ settings (e.g. speed change,
mechanical backlash recovery, positioning tolerance, waiting times, etc.).
Repetitions will be counted when the INCREASE CYCLE input closes.
3
Example after 3 repetitions
3 5 0.5
At the end of the programmed repetitions counting (e.g. after 4 closures), the OK
POSITION output will be disabled.
1 0 0.0
*
The positions will start flashing to
indicate the conclusion of
machining
3 5 0.5
*
To execute a new position in semi-automatic operation, proceed as follows:
0 0 0 0 0.0
*
Press
to set the value of the new
positions to be reached
3 5 0.5
Or, to terminate semi-automatic operation:
1 0 0.0
Press
twice
to go back to manual
operation
3 5 0.5
Summary of Contents for THESI 320
Page 1: ...User Manual Position Controller T TH HE ES SI I 3 32 20 0 www givimisure it...
Page 57: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 57 60 NOTES...
Page 58: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 58 60 NOTES...
Page 59: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 59 60 NOTES...
