GE LPS-D, Instruction Manual

Page: 311 / 436

GE Power Management LPS-D Line Protection System 12-
5
12 ASCII COMMUNICATIONS 12.1 INTRODUCTION
12
GROUP SETTING
The active Protectioning Setting Group number is 1
To select a Setting Group enter Setting Group
Number (‘1’ - ‘4’)
To select active setting group through Contact
Converter Inputs enter ‘0’
To quit press ESC
Enter your choice:
Are you sure (Y/N):? y
New Active Group = 3
Enter digit from
0 to 4; enter
letter
INPuts Request contact converter
status VIEW Contact Converter #0=0 (SETTING GROUP BIT 0)
Contact Converter #1=1 (SETTING GROUP BIT 1)
Contact Converter #2=1
(not assigned)
Contact Converter #3=0 (not assigned)
Contact Converter #4=0 (not assigned)
Contact Converter #5=1 (not assigned)
Contact Converter #6=0 (not assigned)
Contact Converter #7=1 (not assigned)
None
MODEL Retrieve the model
number, serial number,
and version of the relay VIEW MODEL: LPSDA35U143VE3S
VERSION: V0001.11 None
CRCcalc Recalculates the CRC of
various settings groups
(this is primarily a
troubleshooting command
- it is used only where a
relay may have gone
through a loss power
during a settings change,
and the settings are
corrupted beyond the
ability of the relay to
correct). SETTINGS CRCs are recalculated None
STLINID Allows the station and line
IDs to be changed SETTINGS Station ID: Current Station ID
Line ID: Current Line ID
Do you want to change Station and/or
Line ID? (Y/N): y
Enter new Station ID (max. 32 characters): NEW
STATION ID
Enter new Line ID (max. 32 characters): NEW
FEEDER ID
Are you sure? (Y/N): y
Y to change, N
to exit; NEW
STATION ID or
ENTER to keep
current ID; NEW
FEEDER ID or
ENTER to keep
current ID; enter
letter
Table 12–3: ASCII COMMAND LIST (Sheet 4 of 7)
ASCII
Command
Mnemonic Command Description Lowest
Level
Password
Needed Relay Prompt User Response