GE GA000100, Service Manual

Page: 609 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
Chapter 8 - Replacement procedures 8 - 275
8-11-5-3 Front Module installation procedure
Follow these steps to install the Front Module:
1.) Install the Front Module into the BEP frame. Be sure the Front Module lip slides into the Module
opening.
2.) Install the two screws securing the Front Module to the BEP frame.
3.)
BEP6 : Connect the Front Module Cable to the connector on the motherboard.
BEP5 : Connect the cables to the Front Module.
4.) BEP5 only : Install the HDD (if removed).
5.) Install the BEP Cover as described in these steps:
a.) Insert the base of the BEP Cover inside the base of the BEP.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9.
c.) Install the fixing screw(s) for the BEP Cover:
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
6.) Replace the Side Cover.
7.) Install the BEP.
8.) Connect the Mains Power Cable to the wall outlet.
9.) Power up the VIVID E9.
Figure 8-242 Lip on the Front Module
NOTICE
Be careful not to pinch any of the cables when installing the BEP Cover.