– 14 –
Reversing the Door Swing
NOTE: These instructions are for changing the dryer
so that the door opens from the right side.
(
Continued next page
)
Tools Needed:
• Standard #2 Phillips screwdriver
• Tape-tipped putty knife
•
6PDOOÀDWEODGHVFUHZGULYHU
Before Starting
Unplug the dryer from its electrical outlet.
1. Open the door approximately 170 degrees. With
a putty knife, remove the four plastic covers
located along the left side of the front panel and
set them aside.
2. Remove the bottom screw from each hinge
(right side) and partially insert them into the top
left side hinge holes.
NOTE: All four front panel hinge screws will now be
in the top hinge holes; two on the left and two on
the right.
Plastic Cover (4)
Left side of
front panel
3. Loosen the bottom two right side hinge screws.
Remove the door and place it on a protected,
ÀDWVXUIDFHWRDYRLGDQ\GDPDJH5HPRYHERWK
the Blind Plate and the Strike Plate and install
them in opposite positions.
4. Remove the four door hinge screws, the four
edge screws, and the eight inside screws.
/LIWWKHLQQHUGRRUXSZDUGVXVLQJDÀDWEODGH
screwdriver.
NOTE: Some doors may have four inside screws and
four additional edge screws.
Blind plate
Inner door
Strike plate
Door hinge
screws
Inner door
Outer door
Inside screws
Inside screws
Edge
screws
