GE CleanSpeak GTD81ESPJMC, Technical Service Manual

Page: 40 / 57

– 40 –
SERVICE TEST MODE SEQUENCE
DISPLAY MODE
KEY PRESS OR
ACTION
DESCRIPTION
ta
CleanSpeak
Test
Checks the
communications
to the washer
Will display “ON” if OK, will display “Er” if no response.
tb
Water
Valve Test
Start
The control shall enable mist valve, drum tumbles and SSD
shows “On”. When the start button is pressed again drum
VWRSVDQGZDWHUYDOYHLVWXUQHGRȺ66'VKRZV´2))µ
Rotate Knob Returns to service mode screen.
tc
Restores
EEPROM
Start
Clears all power loss data on the EEPROM. Also clears model
ID number.
If selected, model ID will need to be reset. See Set Model ID
test below.
td
Set Model
(see model
ID table)
Start
UI LEDs start blinking
• Press and hold for 3 seconds Time+Level to prepare SSD
for selecting model
• Press Time to decrease the model # selection.
• Press Level to increase the model # selection.
• Once model is selected, press and hold start for 3s to
set model---> unit comes up in the idle state and exits
service mode.
(Continued Next Page)
Dryer Model Codes
DRYER MODEL NUMBER MODEL DESCRIPTION MODEL CODE ID#
GTD81ESSJ0WS
GTD81ESPJ0MC
GTD81ESSJ1WS
GTD81ESPJ1MC Electric 7.8 cu ft, 2 digit, LED icon, My
Cycle settings, ENERGY STAR®
cycle 9 E
GTD81GSSJ0WS
GTD81GSPJ0MC
GTD81GSSJ1WS
GTD81GSPJ1MC Gas 7.8 cu ft, 2 digit, LED icon, My
Cycle settings, ENERGY STAR®
cycle 10 G
GTD86ESSJ0WS
GTD86ESPJ0MC Electric 7.8 cu ft, 2 digit, LED icon, My
Cycle settings, ENERGY STAR®
cycle, Steam, Sanitize, Wi-Fi 13 E
GTD86GSSJ0WS
GTD86GSPJ0MC Gas 7.8 cu ft, 2 digit, LED icon, My
Cycle settings, ENERGY STAR®
cycle, Steam, Sanitize, Wi-Fi 14 G