– 19 –
Dryer Components
WARNING: Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury. Wear
Kevlar® gloves or equivalent protection.
Control Panel
Removal of the control panel provides access to the
control board assembly. The control panel is held
in place with three screws located at the top rear
of the control panel, and also with three shoulder
bolts located on the inside front of the control panel
bottom front.
Control Panel Removal
1. Disconnect the electrical power supply to the
GU\HUDQGWXUQRȺWKHJDVVXSSO\
2. Remove the three 1/4 in. hex head screws from
the top rear backsplash.
3. Grasp the front control panel bottom. Push
down slightly and back at the same time
allowing the control panel to roll forward.
4. Disconnect the RJ45 connector and carefully lay
the control panel on its face to disconnect the
harness connectors from the control board.
5. Remove the control panel rear cover by
removing the two retaining screws, then push
back to disengage it from the two shoulder
bolts.
