– 20 –
Control Board Assembly
The control board assembly is mounted in a plastic
housing that is attached to the inside of the control
panel. It consists of two circuit boards connected by
a wire spine. The boards and the plastic housing are
replaced as an assembly.
Operation of the control board assembly can be
checked by using the service test mode. (See the
Service Test Mode section in this guide.)
)DXOWFRGHVWKDWDUHVSHFL¿FWRWKHFRQWUROERDUG
can initiate fault codes F05 and E06. (See the
Service Test Mode section in this guide.)
Control Board Assembly Removal
1. Disconnect the ACM (Appliance Communication
Module) wire harness from the control panel
rear cover.
2. Disconnect the wire harnesses from the control
panel.
3. Remove the eight Phillips head screws and the
control board frame from the control panel.
