– 7 –
Throughout this manual, features and appearance may vary from your model.
Control Features
(Continued next page)
ESTIMATED TOTAL CYCLE TIME
DELAY
DRY
DAMP
CLEAN
LINT FILTER
DRYING
COOL
DOWN
Energy Smart
50 ~ 60
Extra Dry
Less Dry
70 ~ 80
90 ~ 99
30 ~ 40
10 ~ 20
More Dry
Dry
Damp
No Heat
High
Low
Medium
Extra Low
Time
Temp
Level
Damp
Alert
Delay
Dry
Extended
Tumble
Rack
Dry
Dry
Mixed Loads
No Heat
Permanent Press
Use Timed Dry
Cycles Only
Hold 3 seconds
to CANCEL
Quick Dry
Active Wear
Casuals
Quick Fluff
Delicates
Jeans
Bulky Items
Timed Dry
Normal
Cottons
Sanitized
STEAMselect
Towels / Sheets
Select Steam Cycle and PUSH “STEAMselect” for garment amount
1 to 2
3 to 5
6 to 7
8 to13
Steam Refresh
Steam Dewrinkle
Good
Best
monitor
e
Drum
A
B
C
D
E F
G
H
A
Power
Press to “wake up” the display. If the display is active, press to put the dryer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
B
Start and Pause
Press Start to begin the cycle. NOTE: The door must be closed for the dryer to start the cycle.
Pressing Pause will pause the cycle, the Start will blink and “PAUSE” will scroll across the LCD.
To continue the cycle, press Start again. To stop the cycle, hold the button for 3 seconds.
C
Display and Status Lights
The display shows the approximate time remaining until the end of the cycle.
In addition, this display will, “scroll” the dryer status:
• PAUSE
The message “PAUSE” will scroll across the display when the dryer’s cycle
is paused. The cycle may be re-started by pressing the Start button.
• door
The message “door” will be displayed when the door is opened during the
dryer’s cycle.
• CyCLE
The message “CyCLE” will be displayed when the clothes are dry and
the dryer is recommending a preferred cycle for the next load (see
CleanSpeak™ in the Communication section of this Guide).
• dELAY
The message “dELAY” will be displayed when the Delayed Dry is initiated.
It will be replaced with the estimated time when the cycle starts.
Cycle Status Lights
Shows whether the dryer is in the DRYING, DAMP, or COOL DOWN cycle.
Feature status lights indicate:
The My Settings feature is on for this cycle.
The dryer is locked - will blink once if any button is pressed or the cycle knob is
turned.
The signal is on. See the Variable Signal description under the My Settings
later in this section..
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops.
The eDry feature is selected.
A Delay Dry time is set.
