![background image](http://html.mh-extra.com/html/fujitsu/primergy-bx900-s2/primergy-bx900-s2_upgrade-and-maintenance-manual_121016069.webp)
BX900 S2
Upgrade and Maintenance Manual
69
Basic software procedures
Ê
Enter
4
to set the gateway address of subnet mask.
Ê
Enter
5
to set the TFTP file name.
Ê
Enter
0
to leave the
Network Paramenters
menu.
Ê
Connect the FST to the service LAN connector of the management blade,
see pos. #4 or 5 in
"Connectors on the management blade" on page 183
.
I
The FST must be on the same LAN with the same subnet as the
service LAN port.
Ê
Enter
1
to open the
Upgrade Firmware from Network
menu.
Ê
Open the
Management Blade Update Enable
menu.
Ê
Select
Single MMB firmware update
enable to start the firmware update
process.
Wait until the firmware update is completed.
Ê
Remove the management blade from the system unit. This is done in the
same way as described in section
"Removing a single-width connection
blade" on page 116
.
Ê
Open the management blade, as described in section
"Opening the
management blade" on page 149
and set the Recovery Mode DIP switch
OFF, see
"Management Blade Settings" on page 204
.
Ê
Close the management blade in the opposite order to that described in
section
"Opening the management blade" on page 149
.
Ê
Reinstall the management blade into the system unit,
"Installing the
management blade" on page 145
.