8.5 Replication Wizard
If two targets are already specified, you must delete a target before adding another.
First click
Pause
to pause replication to the target, and then click
Delete
to remove
the target.
Before specifying a target, make sure you have completed the
Replication
wizard on
the target ETERNUS CS800. The target ETERNUS CS800 must be configured to allow the
source ETERNUS CS800 hostname or IP address.
You can specify up to two targets:
a. In the
Target Hostname or IP Address
box, enter the hostname or IP address of
the system that will receive the replicated data.
When entering IP addresses, never use an address that is in a reserved IP address
range. To see a list of reserved IP address ranges, click the quick tip icon
[?]
located near the IP address field.
To use hostname format, you must specify at least one DNS IP address on the
Network
page (see
).
b. (Optional) Select an encryption option:
NONE
Data is not encrypted when sending replication
data to the target system.
AES 128-BIT
Data is encrypted using AES 128-bit encryption
when sending replication data to the target
system.
AES 256 BIT
Data is encrypted using AES 256-bit encryption
when sending replication data to the target
system.
CAUTION!
Select 128-bit encryption if you are sending data to a ETERNUS CS800
running a system software version prior to ETERNUS CS800 2.1.1 Software.
AES encryption options are available only if the Data-in-Flight license is
installed.
c. In the
Source IP Address
field, enter the IP address that is used to uniquely
identify the source ETERNUS CS800 to the target. This may be different than the
actual network IP address of the source ETERNUS CS800.
If the target system is at ETERNUS CS800 2.1 Software or higher, this field is not
required. If the target system is at ETERNUS CS800 2.0.1.x Software or below, then
you must enter the IP address by which the target system recognizes the source
system. The default value is
0.0.0.0
.
2. If data on other ETERNUS CS800 systems will be replicated to this ETERNUS CS800,
ETERNUS CS800
153
Summary of Contents for ETERNUS CS800 S6
Page 1: ...English ETERNUS CS800 S6 User Guide V3 2 7 Edition April 2017 ...
Page 131: ...7 3 The Remote Management Console Figure 98 Remote Management Pages Map ETERNUS CS800 131 ...
Page 173: ...8 8 AIS Connect Figure 132 AISConnect Wizard Confirm ETERNUS CS800 173 ...
Page 449: ...16 2 Storage Subsystem Figure 313 Inserting the 3 5 inch HDD module ETERNUS CS800 449 ...
