6.3 Running the Getting Started Wizard
1. Click
Add IP
to add a network interface to a device.
Or select an interface to edit the IP address, netmask, gateway and traffic type. (To
select an interface, click the radio button next to the interface index name, for
example,
bond0:2
.)
A maximum of 10 IP addresses are allowed per device. All IP addresses in
the IP Address Table (added or modified) must be valid and unique, and
must have a valid gateway and netmask.
2. In the
VLAN ID
column, select the check box to enable VLAN tagging for the interface.
(Or clear the check box to disable VLAN tagging for the interface.)
VLAN tagging allows you to assign an interface to a virtual local area network (VLAN).
With VLAN tagging, you can route different traffic types (management, data, and
replication) over different VLANs, making sure traffic types do not mix.
If VLAN tagging is enabled, enter the
VLAN Tag ID
for the interface. (Valid values are
2
to
4094
. You can assign only one tag ID to an interface.)
Additional Information
l
The maximum allowed number of VLAN tag IDs is 64. If you attempt to add more
than 64 VLAN tag IDs, an error displays.
l
To maintain connectivity, the switch ports connected to the ETERNUS CS800 must
be configured to accept the correct VLAN tag ID.
CAUTION!
If VLAN tagging is enabled for an interface, ETERNUS CS800 Advanced Reporting
is unable to collect and record statistics for traffic moving over the VLAN
interface (for example, eth1.400). Statistics are still collected for the base device
(for example, eth1.)
3. In the
External Host IP
column, select the check box to designate the interface as an
external host IP. This associates the interface IP address with the host name of the
ETERNUS CS800, and the ETERNUS CS800 is externally identified by the host IP. The
following restrictions apply:
l
You can designate only one external host IP for the network configuration.
l
You must specify a traffic type of
Mgmt
(management) or
Any
for the external
host IP interface.
l
You must specify a valid
Default Gateway
in the
General
section. In addition, the
external host IP must be on the same subnet as the
Default Gateway
to ensure
external communication.
4. Enter the following network information as provided by your network administrator
(all fields are required):
ETERNUS CS800
112
Summary of Contents for ETERNUS CS800 S6
Page 1: ...English ETERNUS CS800 S6 User Guide V3 2 7 Edition April 2017 ...
Page 131: ...7 3 The Remote Management Console Figure 98 Remote Management Pages Map ETERNUS CS800 131 ...
Page 173: ...8 8 AIS Connect Figure 132 AISConnect Wizard Confirm ETERNUS CS800 173 ...
Page 449: ...16 2 Storage Subsystem Figure 313 Inserting the 3 5 inch HDD module ETERNUS CS800 449 ...
