75
12 SETUP MENU
PARAMETER
Description
Output 1 Mode
Output 2 Mode
Output 3 Mode
Output 4 Mode
STEREO,
SUM L+R
COPY L>R
MUTE
These four parameters determine how signals at the corresponding output
ports will be processed. This control makes it easy to use the same presets
in a variety of stereo and mono performance or recording environments. The
decision between the mono options “SUM L+R” or “COPY L>R” should be
based on the source material.
See
for more information on these options.
USB Audio goes directly to the converters and is NOT affected by this setting.
The option "MUTE" allows for special use cases involving USB Input
monitoring. See the diagram on
Output 1 Level
Output 2 Level
-10dBV
+4 dBu
These two parameters set the nominal levels of their respective outputs.
Use “-10 dBV” for consumer-grade equipment including many guitar products.
Use “+4 dBu“ with professional audio equipment.
The product manual for your connected device should indicate whether it
operates at +4 dBu or -10 dBV (Default). (Some devices are switchable.)
USB Audio levels ARE affected by this setting.
Output 1 Phase
Output 2 Phase
Output 3 Phase
Output 4 Phase
NORMAL, INVERT
These four parameters determine whether signal at the corresponding output
ports will be normal or phase-inverted relative to its state at the output of
the grid. This lets you compensate for unwanted inversions elsewhere in the
signal chain.
USB Audio signals ARE affected by this setting.
Output 2 | Copy Output 1
OFF/ON
Enabling this option creates a copy of the Output 1 signal at Output 2. Use this
for the convenience of having an extra copy of the Output 1 mix with separate
front panel level control—without the need to insert an additional output block.
This setting does NOT copy USB audio, and only works only when the Output 2
block is NOT present on the grid for the current preset!
Output 3 | Copy Input 1
Output 4 | Copy Input 1
OFF/ON
Enabling either of these options creates a copy of the Input 1 signal at
Output(s) 3 or 4. Use this for the convenience of having an extra copy of the
Input 1 signal (for all-analog re-amping, for instance) without the need to
insert additional output block(s) on the grid.
This setting does NOT copy USB Audio and only works only when the
corresponding output block is NOT present on the grid for the current preset!
For example, Output 3 | Copy Input 1 will NOT copy Input 1 when the Output 3
block is on the grid.
