73
12 SETUP MENU
GLOBAL SETTINGS: OUT 1 EQ & OUT 2 EQ PAGES
Four separate pages — one for each output — each provide an equalizer, plus a master LEVEL adjustment control.
The type of EQ can be changed, or the EQ can be disabled via the EQ Type parameter on the Config page.
Use thes EQs to make global adjustments to the tone or level of ALL presets. This is convenient when you need
to compensate for using a different amp or speakers, or if a particular performance space seems overly bright or
boomy. The master GAIN fader should be used with care as it can cause clipping, and lowering it can affect the
signal-to-noise ratio.
These EQs affect ONLY the Analog outputs. AES/SPDIF/USB are not affected.
NOTE: When Output 2 | Copy Output 1 is enabled, Output 1 Global EQ settings are NOT applied to signals at Out 2.
Instead, the Output 2 Global EQ settings apply as usual.
GLOBAL SETTINGS: CUSTOM SCALES PAGE
The Scales page is used to configure scales for the Custom Shifter type in the Pitch block.
Learn more in
"The Fractal Audio Blocks Guide"
Note that as of firmware 12, global scales can also be edited, exported, and imported using Axe-Edit.
PARAMETER
Description
Custom Scale Number
1–32
Selects from among the 32 global custom scales available to edit using the 12
parameters which follow.
___ SHIFT (+/- 24)
These 12 parameters are used to set the shift amount for each of the 12 steps
of the chromatic scale. Range is +/-24 semitones (+/- two octaves). To set up
a custom scale, select its number in the field above and then set each of the
12 pitch values as desired. Changes take effect immediately, with no need to
STORE. Soft-buttons provide options to reset a selected value or all values in
the current scale to the default value of +/- 0 semitones.