Model D2424LVmkII Reference Manual (Editing Tracks)
74
• Copy & Paste between programs
Copy & Paste between programs can be performed
using the procedures below in the same manner as
in the previous “
Copy & Paste in the same program
.”
1.
2.
3.
4.
5.
6.
7.
8.
Store the copy (or move) start point (CLIPBOARD IN
point), end point (CLIPBOARD OUT point), and the
paste start point (AUTO PUNCH IN point).
Check the stored edit points using the Preview function
and make adjustments if necessary.
Specify the track to be copied and copy it in the clipboard
(Copy Clip).
Switch to program for pasting using the program select
function.
Register the copy starting point (AUTO PUNCH IN point)
in the switched program.
Check the registered editing point with the “Preview
function” and if necessary, correct the editing point.
In the same way as before, enter the editing mode by
pressing the [EDIT] key. “Copy Paste?” will be displayed
after pressing the [EDIT] key.
Next, specify the track and amount to be pasted and
execute paste.
• Checking the clipboard data
Data copied to the clipboard can be confirmed even
after switching the program by the above procedure.
For example, when a specific data in Program 1 is
copied to the clipboard and then switched to
Program 2 in which it is to be pasted, as mentioned
before, if the
[PLAY]
button is pressed while pressing
on the
[STOP]
button, you can listen to data copied
in Program 1 (clipboard play).
During clipboard play, “
P01
” will appear in the
display to indicate that copy data in Program 1 is
being played back.
<Notes>
• Only copy/paste can be executed between
different programs. Move/paste cannot be
executed between different programs.
• Do not copy/paste between programs with
different FS such as copy/paste FS=48kHz
program data to an FS=44.1kHz program.
Sound data cannot be guaranteed if copy/paste
had been executed between programs with
different FS.
Summary of Contents for D2424LVmk2
Page 157: ......
