Panel Saw
Kappa 30 / kappa 40
10.8.2 Assembling the sliding table
Fig. 121: Roller cage
1.
Ensure that the number of rollers of the roller cage
are complete.
2.
Push the cage plate and the roller cage on the base
guides to the centre.
!
Base
"
Roller cage
#
Cage plate
Note: The number of roller cages and the length of the cage plate depends on the length of the sliding
table.
Fig. 122: Base Roller cage
On the base:
7.
Screw the flat head screws in.
%
Allen key
&
Stop screw
/
Washer
3.
Thread the sliding table over the roller cages.
4.
Slide the sliding table a few centimeters over the
guidings of the base.
5.
Push the sliding table further onto the base, however
being careful that the roller cages following are
threaded cleanly between the base and the sliding
table.
6.
Slide the sliding table completely onto the base.
!
Base
"
Roller cage
$
Sliding table
Fig. 123: Base
Maintenance
82
ca 50 %
!
"
#
!
"
$
!
%
&
/
Summary of Contents for kappa 30
Page 93: ......
