Panel Saws
kappa 30/kappa 40
Panel Saw
Kappa 30 / kappa 40
Setup and installation
2.
Adjust the position of the cutting extension with the
setscrews.
3.
Secure the cutting extension with nuts and washers to
the setscrews of the bar.
The saw table determines the exact position and loca-
tion of the bar. If using the cutting extension 1250, lift
the rear end of the bar slightly before screwing it to the
cutting extension.
!
Washer
"
Nut
#
Setscrew
Fig. 34: Cutting extension
Fig. 33: Cutting extension
7.3.5 Cutting extension
The cutting extensions 800 and 1250 mm are screwed
onto the machine frame wall with support brackets.
1.
Secure the cutting extension support bracket to the
machine frame wall with screws, washers and nuts.
!
Support bracket
"
Washers
#
Nut
$
Screws
Attention: It may be neccessary to lift the very rear end of the bar slightly, before screwing the “Cutting
extension 1250” and the stop shaft together.
38
!
"
#
!
"
#
$
"
Summary of Contents for kappa 30
Page 93: ......
