Panel Saw
Kappa 30 / kappa 40
Operation
Warning: Risk of injury!
9.6 Work stations
AP1:
Possible work position for an installed unloader.
AP2:
Work place to operate with parallel cutting fence.
AP3:
Main work place for all other operations.
• Risk of injury due to flying work-pieces and work-
piece parts (e.g. cutting tools, branches, trimmings).
• Risk of kickback from cut work-piece parts.
Therefore never stand directly in the cutting line of the saw
blade whilst it is operating (whilst in cutting or idling mode)!
Fig. 96: Work stations/Work positions
9.7 Working techniques
9.7.1 Permitted working techniques
Only the following working techniques are allowed with
the circular saw:
• Only trim if using a trimming shoe
• Only cross cut using a parallel cutting fence or cross
stop
• Longitudinal cut 90° to 45°, with a parallel cutting
fence and locked sliding table
• Longitudinal cut 90° to 45°, with a crosscut fence
and sliding table
• Splitting large-sized panels
Only the following work techniques are allowed using
the circular saw without a scoring unit:
• Groove cuts/Rabbeting at the parallel cutting fence
• Groove cuts/Grooving at the parallel cutting fence
using dado tooling
69
AP1
AP2
AP3
Summary of Contents for kappa 30
Page 93: ......
