Panel Saw
Kappa 30 / kappa 40
Operation
9.7.12 Working with grooving tools
Fig. 107: Working with grooving tools
Fig. 108: Working with grooving tools
Warning! Risk of injury!
• Groove cuts may only be carried out with an over-
head saw guard! Do not use a saw guard!
• Do not pull back the rip fence‘s guide!
• Removing the splitter!
• Adjust the cutting angle to 90°!
1.
Take note of general procedures for authorized wor-
king techniques.
2.
Set the rip fence to the desired measurement.
3.
Lock the sliding table into a centre position.
4.
Set the cutting height to a maximum of half of that of
the workpiece’s thickness.
5.
Always use the crosscut fence and the sliding table
when making transverse grooves (see „Cutting to
length against the rip fence“).
6.
When feeding the workpiece forward, press it hard
onto the sliding table.
Use an eccentric clamp if required. If an eccentric
clamp is used, shape the groove using the sliding
table.
Attention! Risk of material damage!
Do not adjust the 90° angle when operating with grooving tooling!
75
X
X/2
Summary of Contents for kappa 30
Page 93: ......
