Panel Saws
kappa 30/kappa 40
Panel Saw
Kappa 30 / kappa 40
Making adjustments and preparations
Pivoting:
1.
Loosen the clamping lever and thumb screws.
2.
Pivot the crosscut fence to the desired position. Fold
the end stop back if necessary, so as to be able to
pivot the crosscut fence over it.
3.
Clamp the clamping lever in place and tighten the
thumb screws.
4.
To compensate for the length of the scale when the
fence has been swung out, move the complete fence
towards the saw blade.
8.7 Cross stop
Fig. 44: Cross stop
The cross stop can be pushed onto the crosscut fence in
one movement.
If required, the end stop can be folded back.
1.
Loosen the thumb screw.
2.
Move the cross stop to the desired position. The
measurement (rip capacity) reading is read from the
magnifying lens.
3.
Tighten the thumb screw.
!
Lens
#
Thumb screw
"
Cross stop
$
End stop
Fig. 45: Cross stop
Cross stop (Option Digital display on rip fence):
As an option, the cross stop can be equipped with a
digital display. The measurement (Rip capacity) can be
read from the digital display.
!
Digital display on rip fence
Attention: To operate, programm and calibrate etc. the digital position display, read the separate opera-
tion manual „Position display“.
44
!
"
#
$
!
Summary of Contents for kappa 30
Page 93: ......
