Panel Saws
kappa 30/kappa 40
Panel Saw
Kappa 30 / kappa 40
Setup and installation
Fig. 27: Positioning the machine/Floor mounting
1.
Transport the machine to the installation site as in-
structed in the „Transport“ chapter and the enclosed
transport or installation instructions.
2.
Position the machine with the aid of a spirit level to
ensure that the machine functions precisely and oper-
ates smoothly.
Bolster the machine if the floor is uneven.
!
Spirit level
"
Transport brackets
7.3 Assembly
7.3.1 Sliding table
Attention: Due to transport reasons, the sliding table, depending on its length, may be packaged separate-
ly. Two to three additional helpers, depending on the cutting length, are required to install the machine.
The sliding table has to be set-up before the initial
machine start-up. Individual installation instructions are
found with the machine or the sliding table.
Fig. 28: Assembling the sliding table
1.
Removing the base cover.
2.
Loosen the upper nuts.
3.
Thread the pre-assembled sliding table and base
onto the locking plates.
!
Base cover
#
Nut
"
Locking plate
$
Nut
35
!
"
!
"
#
$
Summary of Contents for kappa 30
Page 93: ......
