Panel Saw
Kappa 30 / kappa 40
Operation
9.7.2 Prohibited working techniques
The following work techniques are strictly forbidden when using the circular saw:
• All work techniques without the use of the parallel cutting fence, cross fence or outrigger.
• Detaching the splitter for single cuts.
*
)
• Groove cuts.
*
)
9.7.3 General procedures for authorised working techniques
*
)
The following departures are valid for the scope of the wood industry‘s employer liability and insurance in the Federal Republic of Germany:
insert cuts and groove cuts are allowed if the appropriate operating regulations of the employer liability insurance are complied with (ZH.I/720).
9.7.4 Trimming
Fig. 97: Trimming shoe
1.
Switch the circular saw off prior to starting work.
2.
Ensure there are sufficient extension options (acces-
sories).
3.
Keep handling auxiliaries at hand:
• Push stick; Wood with holding magnets
(Art. No. 11.2.012)
• Push stick, plastic (Art.-no.: 11.0.010)
• Pushing grip (Art. No.: 11.1.009)
• Deflector with Holding Magnets
(Art. No.: 420-260)
4.
Setting the height/angle of cut.
5.
Modify the overhead saw guard for angular cuts.
6.
Vacuum system must be connected.
7.
Set scoring blade if required.
8.
Only switch the circular saw on, the scoring unit in-
cluded, once the work-piece has been placed in its
position to be cut.
9.
Feed the work-piece constantly past the circular saw,
keeping your fingers balled into a fist.
10.
Use the push stick once at the end of the cut.
11.
Once the cut is finished, switch the machine off.
1.
Take note of general procedures for authorised work-
ing techniques.
2.
Assembling the trimming shoe:
• Thread the trimming shoe into the sliding table
grooves using locking plates.
• Clamp the trimming shoe onto the sliding table
using thumb screws.
3.
Loosen the sliding table lock and pull the sliding ta-
ble back completely.
4.
Place the unfinished plank, with the hollow side fac-
ing downwards, onto the sliding table and clamp in
the trimming shoe.
5.
Switch the circular saw on.
6.
Feed the workpiece evenly past the circular saw,
keeping your fingers balled into a fist.
!
Thumb screw
"
Trimming shoe
§
Groove
$
Sliding table
70
!
"
§
$
Summary of Contents for kappa 30
Page 93: ......
