Ford Cargo 2017, Owner'S Manual

Page: 104 / 240

4
OPERATION
A/C and Heater
Error
code
Error (group) Additional information during computerized diagnosis
Remedy
F 01 Does not start 02 No flame even after restarting 82 Does not start during
testing
Check fuel supply (tank empty, lines blocked) Clean burner
insert, Petrol:
Replace flame sensor Diesel:
Replace overheating sensor / control unit.
F 02 Flame error 03 Flame goes off during operation and not generated again
after starting attempt 83 Flame is distinguished for more than
X times during heating cycle (EEPROM)
Check fuel supply (tank empty, lines blocked) Clean burner
insert, Petrol:
Replace flame sensor Diesel:
Replace overheating sensor / control unit.
F 03 Low voltage or
excessive voltage
84 Voltage is lower than 10.5V or 21 V for more than 20 seconds
04 The voltage was more than 16 V or 32 V for longer than
6 seconds
Charge the battery.
F 04 Premature flame
detection
05 A flame is detected before the combustion Diesel: Replace overheating sensor / control unit.
Petrol: Replace the flame sensor.
F 05 Interruption or short
circuit in flame sen-
sor (petrol heater
only)
1A Flame sensor circuit
Short circuit to chassis in the switched wire of the element
9A Flame sensor circuit
Wire fault or short circuit to +Ub
Replace the flame sensor. Replace the flame sensor.
F 06 Fault or short circuit
on the external tem-
perature sensor
14 Temperature sensor circuit Short circuit to ground
94 Fault on the temperature sensor circuit or short circuit to +Ub
Check the wires / replace the temperature sensor
Check the wires and termination resistance / replace the
temperature sensor
F 07 Interruption or short
circuit in metering
pump
88 Fault or short circuit to +Ub 08 Short circuit to ground Check the wires / replace the metering pump
Check the wires / replace the metering pump
102