Ford Cargo 2017, Owner'S Manual

Page: 143 / 240

4
OPERATION
Manual Control Unit (In Vehicles with
6 x 2 Air Suspension)
Chassis height of the vehicles with 6x2 air
suspension may be adjusted. ECAS control is
placed on the left of the driver's seat.
1- N/A- This button is not active.
2- Rear axle activation light
3- N/A- This button is not active.
4- Driven axle selection button
5- M1 Memory button
6- M2 Memory button
7- Normal drive height button
8- Lifting button
9- Lowering button
10- Stopping button
11- Lifted axle selection button
1. Ignition switch should be in position 2 to
activate the air control system by the "manual
control unit". work has been performed.
2. Functions desired can be performed after
pressing the 4 driven axle selection button or
11
lifted axle selection button.
3. Press the "STOP" button if you need to stop
the operation during any procedure.
4. If you want to record a certain chassis
height, press the "STOP+M1 or M2" buttons
for 2 seconds at the same time. This would
record the height to the system. In the future,
when you want to adjust the vehicle to this
height, press M1 or M2 button after you press
the "front selection - rear axle" button.
In the future, when you want to adjust the
vehicle to this height, press M1 or M2 button
after you press the "front selection - rear axle"
button.
WARNING
Do not tamper with the rear suspension load
detection sensor connections of your vehicle
and do not have ECAS values changed.
ECAS (Electronically Controlled Air Suspension)
141