4
OPERATION
Manual Control Unit (In Vehicles with Air
Suspension with Four Bellows)
Chassis height of the vehicles with 4 air
bellows on rear axle may be adjusted by the
control.
ECAS control is placed on the left of the
driver's seat over the fender.
WARNING
Do not change the chassis height of your
vehicle by the manual control unit when driving.
Use the manual control unit when your vehicle
is stationary and parking brake is applied.
This is important for the safety of you and your
vehicle.
Using Manual Control Unit (Only In Vehicles
with Air Suspension with 4 Bellows)
1- N/A
2- Rear axle activation light
3- N/A
4- Driven axle selection button
5- M1 Memory button
6- M2 Memory button
7- Normal drive height button
8- Lifting button
9- Lowering button
10- Stopping button
1. Ignition switch should be in position
2
to activate the air control system by the
"manual control unit".
2. Functions desired can be performed after
pressing the
4
driven axle selection
button .
3. Press the "STOP" button if you need to
stop the operation during any procedure.
4. If you want to record a certain chassis
height, press the "STOP+M1 or M2"
buttons for 2 seconds at the same time.
This would record the height to the
system. In the future, when you want to
adjust the vehicle to this height, press M1
or M2 button after you press the "front
selection - rear axle" button.
NOTE:
marked buttons are not active.
Symbol is illuminated on the
instrument when the vehicle is not at driving
height
ECAS (Electronically Controlled Air Suspension)
140
Summary of Contents for Cargo 2017
