FOR-A VSF-128128, Operation Manual

Page: 63 / 106

51
9-2-5. Salvo Calling
This command performs simultaneous switching to the crosspoints stored to a salvo
registration number.
Parameters:
Item Parameter Description
Salvo No. 01 to 16 Salvo registration number
Operation is performed as follows when a destination lock (see “9-8. Destination Lock”) or
crosspoint inhibit (see “9-7. Crosspoint Inhibit”) is set for the destination channel registered
for salvo switching.
If the serial control device (PC) itself that is currently being used is set to LOCK OTHER,
the crosspoint switching is executed. A reply message of completed normally is returned.
If LOCK OTHER is set by a remote control unit other than the serial control device that is
currently being used, switching for the destination channels set to LOCK OTHER in the
recalled salvo switching (simultaneous switching) operation will be separated and not be
performed. A reply message of completed normally is returned.
If LOCK ALL is set, switching for the destination channels set to LOCK ALL in the recalled
salvo switching (simultaneous switching) operation will be separated and not be
performed. A reply message of completed normally is returned.
If crosspoint inhibit is set, switching for destination channels set to crosspoint inhibit in the
recalled salvo switching (simultaneous switching) operation will be separated and not be
performed. A reply message of completed normally is returned.
Command SE Salvo No (2) CR+LF
Response OK CR+LF
（
Ends normally
）
ER CR+LF
（
Ends abnormally
）