General operation
Page 138 Panel Generator Control P6+ RE0703_Kunde_eng.R02 - Chapter A: General operation
8.7.08
A.6 Automatic adapter - option
Fischer Panda Art. No. 21.02.02.016H
Fig. A.6-1: Panel 21.02.02.009H with Automatic adapter 21.02.02.016H
Function:
The automatic adapter RE0704 extends the generator control panel P6+ with an automatic input. A potential-free
contact can be attached to this input. If this contact is closed, then the generator, which is attached to the genera-
tor control panel P6+, is started automatically. If the contact is opened, then the generator is stopped automati-
cally.
The automatic starting procedure consists of pre-heating (heat) and operating the starter (start). It can be again
aborted at any time by opening the contact at the automatic input.
For automatic stopping (stop) the output “Fuel pump” (clamp 9 generator control panel) is switched off. The time
for the automatic stop procedure can be terminated only by switching off generator control panel prematurely.
The times for “heat”, “start” and “stop” are separately adjustable (see below).
The additional automatic adapter switched on and off using the generator control panel with its push buttons “on”
and “off”.
If the contact at the automatic input is connected, while the generator control panel is switched on, then the auto-
matic starting procedure is carried out.
If the current supply is attached or switched on using the generator control panel, while the contact of the automa-
tic input is closed, then the automatic starting procedure won´t be carried out, because the generator control
panel is always switched off after attaching the current supply (generator the control panel must have been sepa-
rate from the current supply for at least 60s).
01
02
03
01. Main terminals
02. Automatic adapter 21.02.02.016H
03. 8-pole DIP-switch
