Festo HSP AE Series, Manual

Page: 120 / 174

5. Commissioning with the control panel
5−28
Festo P.BE−HSP−AE−IO−EN en 0510NH
5.5.3 Adapting existing positioning sets
Please note
The settings do not become effective in the drive until
they are saved with [Save]. Only then will the settings be
retained even if the power supply is switched off or if there
is a power failure.
The positioning set table is shown under [Diagnostic]. You can
scan the complete current parametrizing of a positioning set
with [Settings] [HSP Setup] [Position set] [Save].
1. Activate the desired positioning set (0...14) with [Settings]
[HSP Setup] [Position set] [Position nr].
2. Select the desired parameter for modifying an existing
positioning set. Note the instructions on parametrizing in
chapter 5.5.1.
3. Then select [Save] in order to save the positioning set.
All current settings will be displayed. Check the settings
shown and confirm the positioning set with [OK].
}
HSP Setup
Position set
Position nr
Pos set mode
Torque
Position
Velocity
Save
}
HSP Setup
Position set
Position nr
Pos set mode
Torque
Position
Velocity
Save