Festo HSP AE Series, Manual

Page: 39 / 174

2. Fitting
2−3
Festo P.BE−HSP−AE−IO−EN en 0510NH
2.1 Instructions on fitting
Warning
Sudden unexpected movement of the connected actuators
and uncontrolled movements of loose tubing can cause
injury to human beings or damage to property.
Switch off the following before undertaking fitting:
the compressed air supply to the attached components
the operating voltage supply for the motor.
Please note
Handle all modules and components with great care.
Please note especially the following:
Screw connections must be fitted free of offset and
mechanical tension. Screws must be fitted accurately
(otherwise threads will be damaged).
The specified torques must be observed.
The modules must not be offset.
Contact surfaces must be clean (avoid contact faults).
Observe also the installation instructions supplied with
modules and components ordered at a later stage.
Caution
If mechanical modifications have been undertaken since
commissioning, the reference system and the end posi
tions must be taught again. Carry out the following com
missioning steps:
after turning/swivelling the motor unit (type HSP−...−GE),
after setting the y−stroke,
after setting the z−stroke,
If the load changes, take the modified work load into
consideration.