Factory Five Racing '33 Hot Rod, Assembly Manual

Page: 647 / 710

646
www.factoryfive.com 508-291-3443
Cut the connector off the tail light wires which will also cut the license plate wires.
Push the tail light wires through the grommet into the trunk so they will reach the light.
Strip the ends of the tail light wires and the harness wires.
Twist the license plate wires back onto the correct harness wires.
Wire the tail lights to the harness using either butt connectors or solder.
Cut the wire loom outside the trunk so that the loom ends at the grommet.
Put the wire loom on the wires in the trunk.
License plate bracket

Wire strippers, wire crimpers, electrical tape, drill,
3
/
16
” drill bit, rivet tool, measuring tape, marker

License plate mounting components, secondary body fasteners.

The license plate lights are also the mounting bolts for the license plate, they can not get wired until
after a plate is mounted.