Factory Five Racing '33 Hot Rod, Assembly Manual

Page: 349 / 710

348
www.factoryfive.com 508-291-3443
Push the ball stud retainer onto the throttle pedal.
While pulling the cable tight, push the accelerator pedal up until it hits the frame and align the ball stud
retainer with the cable.
Mark on the cable where the retainer ends.
Measure ⅜” from the mark on the cable towards the end of the cable and re-mark the cable.
Using a pair of wire cutters, cut the cable at the new location marked.
Remove the ball stud retainer from the accelerator pedal.
Push and twist the ball stud retainer onto the end of the cable and attach the ball stud retainer using a
5
/
64
”
hex key.
Check the full range of the accelerator pedal travel to ensure that there are no interferences with the pedal
or travel.

After driving the car for the first time you may want to adjust the pedal location for optimum
heal/toe and shoe size differences.
Seat Harnesses
 ¾” wrench, ¾” socket, ratchet

Seat harnesses/fasteners

These have to be installed before the body because the bolt may be difficult to install with the body in
place.

Even if you are not going to install the upper seat harnesses, place the bolt and nut on the chassis as
shown in case you or the next owner decided to install them. This makes is much easier in the future.
The shoulder part of the harness is mounted to the U-shaped bracket above the gas tank.