Factory Five Racing '33 Hot Rod, Assembly Manual

Page: 434 / 710

433
www.factoryfive.com 508-291-3443
Turn the panel upside down and drill the hole positions marked using a 1¾” hole saw. Make sure that the
hole saw is angled like the rollbar would be and
not perpendicular to the panel surface.
Look at the bottom edge mark drawn on the rear cockpit aluminum. The mounting screws for the rear
cover need to go into the 1.50” tube.
Measure up to the center of the 1.50” tube.
Mark the rear cockpit cover this same distance up from the bottom edge.
Temporarily remount the panel and check the fit of the rollbar by sliding it down into the mounts. If
necessary use a file to open the holes where necessary.
Drill the lower mounting holes through the cover and into the 1.50” tube on the line marked on the cover.
Remove the rear cockpit cover.

The rear cockpit cover can be sent out for paint with the body or sent to get covered or see the
installation section later for vinyl covering
Trunk

Orbital sander, 80 grit sand paper, masking tape, jig saw or air saw, marker.

Trunk, secondary body fasteners

The trunk is cut oversized at the factory to allow for maximum adjustment and to allow the customer
to set their own desired panel gaps.
Fit the trunk to the trunk opening of the body.