Factory Five Racing '33 Hot Rod, Assembly Manual, Page: 276 / 710

275
www.factoryfive.com 508-291-3443
Run the fuel line down sharply to the lower inside of the side 1.50” tube. The lower the better (but above
the bottom of the tube) to keep it away from the exhaust if you are going to run the side exit pipes.
Position insulated line clamps to hold the fuel line every 12” or on each side of a bend.

Use either the small insulated clamps for each of the lines (hard on the
5
/
16
” size) or put both lines in a
single ⅝” clamp.
Use the clamp hole as a guide and drill
3
/
16
” rivet holes then place the rivet in the hole to hold it in place
but do not pull the rivets with the rivet tool yet.
Measure and cut a 3” section of the rubber
5
/
16
” fuel hose to connect the fuel filter to the 5
/
16
” hard line.
Connect the rubber fuel line to the quick connect fitting using one of the fuel injection hose clamps.
Connect the other end of this rubber line to the barb on the
5
/
16
” hard line.

If you are not running a return line, skip the next part and continue with the
5
/
16
” line.
¼” Fuel line
Attach a barb on one end of one of the ¼” fuel lines.
Remove the plastic locking clip from one of the ¼” quick connect fittings and push it onto the return of
the fuel pick-up.