Factory Five Racing '33 Hot Rod, Assembly Manual

Page: 601 / 710

600
www.factoryfive.com 508-291-3443
Install the rear cockpit cover.
Measure up and mark the rear cockpit cover in the corners under the rollbar holes the distance just
measured.

The rear cockpit cover should now be marked 1” below the top of the rollbar frame mount.
Looking down from above so that you can see the rollbar mount, use a
3
/
16
” drill bit at the height marked
to drill through the fiberglass and mark the side of the rollbar mounts.
Remove the rear cockpit cover.
Install the rollbar to the height desired.
Clamp the rollbar so that it can not slide down into the mount tube.
Drill all the way through both the mount tube and rollbar using a
3
/
16
” bit first followed by a
5
/
16
” and then
½” bit at the point marked by the 3
/
16
” bit earlier.
Insert one of the supplied quick release pins through the mount hole, make sure it can go in and out
smoothly and that the ball in the end of the pin goes completely through the mount tube.
Drill the other rollbar leg the same way and test fit the mounting pin.
Remove the rollbar.