Factory Five Racing '33 Hot Rod, Assembly Manual

Page: 394 / 710

393
www.factoryfive.com 508-291-3443
If necessary, remove the arm and cut more of the slot out.
Remove the arms from the standoffs.
Door fitment

Orbital sander, 80 grit sand paper,
5
/
16
” drill bit, drill, masking tape, jig saw or air saw.

Doors

The doors are cut oversized at the factory to allow for maximum adjustment and to allow the customer
to set their own desired panel gaps.
Hold the door in position and note the areas that need to be trimmed to allow the door to fit in the opening
and allow the half moon trim accent of the door to align with the trim on the body.
Mark the areas with a marker.
Remove the door and sand the marked areas in long smooth movements to prevent notches from
occurring using an orbital sander and 80 grit sand paper. Make two or three passes over the areas only.
Recheck the door fitment and sand more if necessary.
Use masking tape to hold the door onto the body.