Factory Five Racing '33 Hot Rod, Assembly Manual, Page: 187 / 710

186
www.factoryfive.com 508-291-3443
Locate the fuel tank wires in the rear harness and run them forward just behind the rear 1.5" square tube to
which the roll bar is attached.

If you need more length on the fuel system wires, pull the loom back and cut the electrical tape so
the wires can move forward a few inches.
If you are running an inline fuel pump, separate the fuel pump wires from the fuel level sender wires by
undoing the electrical tape and loom.

The fuel pump will get located on the right/middle side of the frame while the fuel level is on the
left side of the frame.

An in tank pump is close to the fuel level sender so it is not necessary to separate the wires.
Temporarily attach the rear light wires to the rear of the frame. Later these will get routed around the
trunk aluminum to the tail lights.

If you are going to install a stereo in the car and plan to have rear speakers, now is a good time to
run the rear speaker wires to the back of the cockpit inside the rear harness loom.
Starting at the back of the frame at the harness “T”, use the ⅝” line clips and
3
/
16
” rivets to attach the
harness to the frame.