Extreme Networks Summit 200-24, Hardware Installation Manual

Page: 369 / 386

Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide 369
E
Installing the Summit Option Card and
XENPAK Modules
The Summit XEN Card or XGM-2xn Option Card is an additional card that adds one or two 10 Gigabit
uplink modules to the back of the Summit 400-48t switch. Two models of the Summit option card are
available:
• Summit XEN Card
• Summit XGM-2xn Card
The Summit option card supports any of these Extreme XENPAK optical transceivers:
• SR XENPAK, operating in the 850 nm range
• LR XENPAK, operating in the 1310 nm range
• ER XENPAK, operating in the 1550 nm range
• ZR XENPAK, operating in the 1550 nm range
Because of power and thermal limitations, the use of ZR XENPAKS in the XGM-2xn Option Card is
limited to one of the configurations listed in Table 129.
This appendix provides instructions to install the option card and the uplink module.
NOTE
The Summit XGM-2xn Option Card requires ExtremeWare 7.4 or later. Be sure to upgrade your Summit
switch to ExtremeWare 7.4 (or later) before you install a Summit XGM-2xn Option Card. Installing a
XGM-2xn Option Card without the correct supporting software might prevent the switch from booting.
Table 129: ZR XENPAK Combinations
Left Slot Right Slot
ZR XENPAK Empty
ZR XENPAK SR XENPAK