Extreme Networks Summit 200-24, Hardware Installation Manual

Page: 200 / 386

200 Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Alpine 3800 Series I/O Modules
WM-4T1i Module
Figure 113 shows the WM-4T1i module.
Figure 113: WM-4T1i module
The WM-4T1i module has four T1 ports, using RJ-48 connectors, and two 10/100 Mbps autonegotiating
Ethernet ports, using standard RJ-45 connectors. The WM-4T1i also has eight internal loopback ports
that allow you to configure bi-directional rate-limiting without tying up any of the external ports for
ingress rate shaping. Internal loopback ports are marked with the notation “iL” when displayed on the
command line or with ExtremeWare Vista Web access. The WM-4T1i module supports T1 and
autonegotiation of 10BASE-T and 100BASE-T.
The default configuration of the WM-4Ti module is as follows:
•
The four T1 ports allow 1.54 Mbps.
• The other two ports in autonegotiation mode allow 10 Mbps or 100 Mbps, and full duplex or
half-duplex operation.
WARNING!
To reduce the risk of fire, use only 26 AWG or larger telecommunication line cord.
You must ground the Alpine 3800 series chassis to ensure safe operation of the WM-4T1i module. For
information about grounding requirements for the Alpine 3800 series chassis, see “Grounding the
Alpine 3800 Series Chassis” on page 155.
LEDs
The WM-4T1i module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the WM-4T1i module, see “I/O Module LEDs” on
page 202.
Software Requirements
The WM-4T1i module requires ExtremeWare version 6.1.5 or later and BootROM 6.5 or later on the
switch.
For more information about software requirements and WM-4T1i module configuration, see the
ExtremeWare Software User Guide and the ExtremeWare Command Reference Guide .
38_WM4T1
Module status LEDs
Port status LEDs
T1 ports
10/100 Mbps ports